NEC NC1700L - Page 58

58
Setting Up Your Projector and Chiller Unit
3
Orient so that the connector on the lens unit is on the right side, then insert the lens into the
projector.
Orient so that the connector on the
lens unit is on the right side
4
Turn the lens clockwise.
Rotate until it clicks to lock the lens unit into the projector.
5
Mount the front cover to the projector.
This completes the installation of the lens.
NOTE
Perform the following steps before adjusting the lens.
• Common to all lens units
Configure the lens type setting and select the lens type that matches the lens unit that is attached (page 84).
• Lens units that support the lens memory function
Execute lens calibration after configuring the lens type setting (page 85).