NEC P502HL - Update the Software

115
9. Appendix
❶ Troubleshooting
Thissectionhelpsyouresolveproblemsyoumayencounterwhilesettinguporusingtheprojector.
Indicator Messages
POWERIndicator
Indicator Condition ProjectorCondition Note
Off The main power is off –
Blinking
light
Blue
0�5 sec On,
0�5 sec Off
The projector is getting ready to turn on� Wait for a moment�
2�5 sec On,
0�5 sec Off
Off Timer is enabled�
Program timer (off time enabled)
–
Orange (short flashes) Cooling Wait for a moment
Orange (long flashes) Program timer (on time enabled)
Steady
light
Blue
The projector is turned on� –
Orange In Standby condition [NETWORK STAND-
BY] is selected for [STANDBY MODE]
–
Red In Standby condition [NORMAL] is
selected for [STANDBY MODE]
–
STATUS Indicator
Indicator Condition ProjectorCondition Note
Off Normal or Standby –
Blinking
light
Red
2 cycle (0�5 sec
On, 0�5 sec Off)
Temperature error The projector is overheated� Move the projector to a
cooler location�
3 cycle (0�5 sec
On, 0�5 sec Off)
Power error Power unit is not working properly� Contact your dealer�
4 cycle (0�5 sec
On, 0�5 sec Off)
Fan error Fans will not work correctly�
6 cycle (0�5 sec
On, 0�5 sec Off)
Light source error Ask your dealer or service personnel for repair�
Orange 1 cycle (0�5 sec
On, 2�5 sec Off)
Network conflict Both the built-in wired LAN and the wireless LAN cannot
be connected to the same network at the same time�
To use both built-in wired LAN and wireless LAN at the
same time, connect them to different networks�
NOTE:IntheStandby condition,thestatusindicator
on the cabinet does not blink in orange evenif the
networkconicts
Steady
light
Green Sleep mode* –
Orange
CONTROL PANEL LOCK is on� You have pressed cabinet button when Control Panel
Lock is on�
CONTROL ID error Remote control ID and projector ID are not matched�
* Thesleepmodereferstothemodeinwhichtherestrictionstofunctionsduetothe[STANDBYMODE]settingshavebeenelimi-
nated.
LIGHT Indicator
Indicator Condition ProjectorCondition Note
Off No trouble or [ECO MODE] is set to [OFF]� –
Steady
light
Green [ECO MODE] is set to [ECO1] or [ECO2] –