NEC P502HL - Turning off the Projector

24
2. Projecting an Image (Basic Operation)
❾ Turning off the Projector
Toturnofftheprojector:
1. First, press the (POWER) button on the projector
cabinet or the STANDBY button on the remote control.
The confirmation message will be displayed.
• Theconrmationmessagedisplayedwhenthepower
is turned off indicates the amount of CO2 reduction this
session (→ page 29).
2. Secondly, press the ENTER button or press the
(POWER) or the STANDBY button again.
When the light source turns off, the power turns off too. The
cooling fan remains to run for a while. When the cooling fan
stops to run, the projector will go into the STANDBY mode.
When in standby mode, the POWER indicator will light red
and the STATUS indicator will turn off when [NORMAL] is
selected for [STANDBY MODE].
Power On
Steady blue light
Standby
Steady red light
3. Mount the lens cap.
 Insertthecap’s2(two)hooksintothegroovesoftheprojec-
tor, then press at the bottom of the lens cap. The stopper
is secured to the projector.
Hook
Stopper
CAUTION:
PartsoftheprojectormaybecometemporarilyheatediftheprojectoristurnedoffwiththePOWERbutton.
Becarefultohandletheprojector.
NOTE:
• Donotunplugthepowercordfromtheprojectororfromthepoweroutletwhileanimageisbeingprojectedandthecoolingfan
isrotating.Doingsocoulddeterioratetheprojector’sACINterminalorthepowerplug’scontact.DonotshutofftheACpower
supplywhileanimageisbeingprojected.DonotdisconnecttheACpowercorduntilthePOWERindicatorturnsONinred.