NEC P502HL - ❸ Part Names of the Projector; Front; Mounting the Lens Cap Strap

4
1. Introduction
❸ Part Names of the Projector
Front
IntakeVent
(→ page 113)
Lens shift cover
(→ page 17)
Lens Cap
Tilt Foot
(→ page 20)
IntakeVent
(→ page 113)
Remote Sensor
(→ page 9)
Focus Ring
(→ page 19)
Indicators
(→ page 6)
Zoom Lever
(→ page 19)
Lens
MonauralSpeaker
Mounting the lens cap strap
1. Insert the tip of the strap into the lens cap mount hole and pass
the knot through.
Lens cap mount hole
2. Insert the knot into the strap mount hole (large) on the bottom of
the projector, then press it into the narrow (small) hole.