NEC P502HL - ❹ Attaching the Optional Cable Cover (NP08 CV); Attaching the Cable Cover

122
9. Appendix
❹ Attaching the Optional Cable Cover (NP08CV)
Afternishingconnections,attachthesuppliedcablecovertoproperlyhidethecables.
CAUTION:
• Besuretotightenthescrewsafterattachingthecablecover.Failuretodosomaycausethecablecovertocome
offandfall,resultingininjuryordamagetothecablecover.
• Donotputbundledcablesinthecablecover.Doingsomaydamagethepowercord,resultinginare.
• Donotholdthecablecoverwhilemovingtheprojectorordonotapplyexcessiveforcetothecablecover.Doing
somaydamagethecablecover,resultingininjury.
Attaching the cable cover
Toolneeded:
• Phillipsscrewdriver(plus-head)about9cm/4inchesinlength
9 cm/4 inches
1. Align two claws on the cable cover edge with grooves of
the projector and push the top end.
• The remaining claw on the cable coveralso goes in the
projector’s groove.
NOTE:
• Becarefulnottogetcablescaughtinbetweenthecablecoverand
theprojector.
1
2
* As seen from below.
Claw on the cable cover
edge
Grooveinback
panel
Cable cover
claw
2. Tighten the cable cover screws.
• Besuretotightenthescrews.