NEC PC-8201A - Page 31

Chapter 2
Cold Start for Banks #2 and #3
If the memory has been expanded to make Banks #2 and #3
available, a Cold Start must be performed for each of these banks
after installation of the additional RAM.
This type of Cold Start is performed in the MENU mode. The
steps for the Cold Start of Bank # 2 are performed while displaying
Bank #1, and the steps for the Cold Start of Bank #3 are performed
while displaying Bank #2. The two steps of the Cold Start must be
performed one right after the other, with no time lapse between the
two. The Key is kept depressed during both steps:
1. Press the f.5 Function Key while keeping the Key
depressed. The screen will clear for an instant at this time.
2. Press the Key immediately after pressing the f.5 Function
Key, while the Key remains depressed and the screen is
clear.
This process will not work if the Key is released before step 2
is completed. The screen clears instantly after step 1, and step 2
must be performed dur ng the instant that the screen is cleared,
before a new screen is displayed.
If the Cold Start for Banks # 2 and #3 does not work, try it
again. It is possible that too much time lapsec between steps 1 and
2, even if you thought that they were performed quickly enough.
Bank #2 should be cleared of all files after the above Cold Start is
performed successfully. To clear Bank #3, the process in steps 1
ard 2 above are repeated exactly as in the Cold Start performed for
Bank #2, with the exception that the procedure would be started
from Bank #2.
2-3