NEC Pinwriter P2000/P2X - Loading Cut Sheets with Continuous Paper Parked

Section 4 PaDer Loadina 27
Markings
Trattor Cover
f oading Cut Sheets with Continuous Paper Parked
You tan load and print tut sheets without removinp continuous Paper fiom the
tractor by using a feature termed “Paper park&.” You back-feed the continuous
Paper off the platen, “parking” it on the tractor while you load tut sheets. Then,
refeed the continuous Paper when you need again.
Follow these Steps to use Paper parkin; when you have continuous Paper loaded in
the Printer and you want to print tut sheets.
NOTE: The Paper parking feature tan oniy be used with the tractor installed as a push tractor.
8 Press FEEDROAD and MODE simultaneously. The Printer will perform
reverse line feeding, moving the continuous Papers away from the platen.
NOTE: If the continuous Papers are not away from the platen, press FEEDROAD and
MODE simuitaneously again.
0
0
0
8
0
Set the Paper selection lever to the rear Position.
Load a tut sheet into the Printer (see page 22).
After printing on a tut sheet, press FEEDROAD one second or more to eject a
tut sheet.
After a tut sheet is ejected, set the Paper selection lever to the front Position.
Fress FEEDILOAD. The continuous Papers retum to the first print line.