NEC QX-S5526P User Manual

Installation Guide
QX-S5500 Series Ethernet Switches
6
Upgrading Software
***********************************************************
* *
* NEC QX-S5526P BOOTROM, Version 509 *
* *
***********************************************************
Copyright (c) 2004-2009 NEC Corporation. All rights reserved.
Creation date : Jan 9 2009, 10:44:09
CPU Clock Speed : 533MHz
BUS Clock Speed : 133MHz
Memory Size : 256MB
Mac Address : 000fe287b008
Press Ctrl-B to enter Boot Menu... 1
Press <Ctrl+B>. The system displays:
Password:

NOTE:
To enter the Boot Menu, you must press <Ctrl+B> within two seconds after the information “Press Ctrl-B to
enter Boot Menu...” appears. Otherwise, the system starts to decompress the program; and if you want to enter
the Boot Menu at this time, you will have to restart the switch.
Input the correct Boot ROM password (by default, no password is set on the switch). The
system enters the Boot Menu:
CAUTION:
Don't forget the Boot ROM password to which the switch was changed during use.
Software of Version 5.4.12 or later version:
BOOT MENU
1. Download application file to flash
2. Select application file to boot
3. Display all files in flash
4. Delete file from flash
5. Restore to factory default configuration
6. Enter bootrom upgrade menu
7. Skip current configuration file
8. Reserved
9. Set switch startup mode
0. Reboot
Ctrl+F: Format File System
Ctrl+D: Enter Debugging Mode
Ctrl+T: Enter Board Test Environment
Enter your choice(0-9):
Software of Version 5.4.8 or previous version:
BOOT MENU
1. Download application file to flash
2. Select application file to boot
6-2

NEC QX-S5526P Specifications

General

Brand	NEC
Model	QX-S5526P
Category	Switch
Language	English