NEC SL1100 - Figure 3-2 Transfer Call - Start; Hang up; Transfer Call - Blind; Transfer Call - Cancel

SL1100 Issue 1.0
Desktop Suite 3 - 3
___________________________________________________________________________________
___________________________________________________________________________________
1.3.1 Transfer Call – Start
When the Start button is selected, the software will initiate a
supervised transfer of
(blind transfer may be selected from the Shortcuts
tab in Preferences)
the call. The Transfer dialog will be updated (refer
to Figure 3-2 Transfer Call – Start).
 Selecting the Complete button will connect the original caller to the
destination and disconnect the user.
 Selecting the Disconnect button will hang up from the call to the
Destination, and reconnect to the original caller.
1.3.2 Transfer Call – Blind
 When the Blind button is selected, the application will initiate an
unsupervised transfer to the specified destination.
 Once the transfer is complete, the active call will be removed from the
active call area.
1.3.3 Transfer Call – Cancel
 When the Cancel button is selected, the transfer operation will be
cancelled and the Transfer dialog will be closed.
 Pressing the Esc key will also initiate the Cancel operation.
1.4 Hang Up
 The Hang Up button will disconnect the user from the active call.
 When the active call is disconnected, the associated entry in the Active
Call list will be removed.
Figure 3-2 Transfer Call – Start