4.4 Mounting the VoIP Daughter board
The IP7WW-VOIPDB-C1 daughter board is used to convert the RTP (Real Time Transfer Protocol)
packets via the IP Network and PCM highway. The daughter board is installed on the CPU board.
1) Ensure the Chassis are powered off and unplug the AC cord
2) Loosen two screws and pull out the CPU board if the CPU is installed.
3) Use micro nippers to
cut and remove the plastic knockouts (for VoIPDB) of CPU-C1 board.
!! For your safety, smooth the cut edges after removing the plastic knockout.
4) Install the VOIPDB-C1 board to J2 connector on the CPU board and tighten the four screws
from the back side if there is no EXIFB-C1.
To Next Page
Loading...
