NEC SL2100 - Time and Date Setting; Program10-01-XX

SL2100 GETTING STARTED GUIDE
52
Scroll Cursor to the left…….
Scroll Cursor to the right…….
2.5 Time and Date Setting
Use this setting to change the time and/or date displayed, for example, when the time and date on the multiline
telephone is not correct. Below shows the steps for changing the time and/or date.
2.5.1
Program10-01-xx
No.
Operation
Display Shows;
1
After logging into Programming Mode.
2
Dial 10 01 01.
Edit the last two digits of the year (e.g., 17) you can overwrite the
current entry.
Press Hold key to confirm the entry and step to the next option.
3
Enter the two digits of the month (01-12).
Press Hold key to confirm the entry and step to the next option.
4
Enter the two digits of the day (01-31).
Press Hold key to confirm the entry and step to the next option.
5
Enter the two digits of the hour (24-hour format).
Press Hold key to confirm the entry and step to the next option.
6
Enter the two digits of the minutes (00-59).
Press Hold key to confirm the entry and step to the next option.
7
Enter the two digits of the seconds (00-59).
Press Hold key to confirm the entry and step to the next option.
8
When you are done, press Mute
key several times to return to
Programming Mode.
9
Press Speaker key to save changes and exit from Programming
Mode.
←
→
10-01-01_________________
Year__________17________
___←_______________→___
10-01-02_________________
Month__________1________
___←_______________→___
10-01-03_________________
Day __________20________
___←_______________→___
10-01-05_________________
Hour _________18________
___←_______________→___
10-01-06_________________
Minute_________50________
___←_______________→___
10-01-07_________________
Second________ 3________
___←_______________→___
_________________________
______Program Mode_______
_Base_Service_OP1__OP2__
____1-20_FRI__ 6:51PM____
101______________DONALD
_Menu__Dir__VM:00_CL:00_
_________________________
______Program Mode_______
_Base_Service_OP1__OP2__