Configuration Note 3. Configuring NEC SV8100 IP-PBX
Version 7.0 13 AudioCodes Mediant E-SBC
3 Configuring NEC SV8100 IP-PBX
This chapter describes how to configure the basic parameters of the NEC SV8100 PBX to
operate with AudioCodes E-SBC.
Note: For more complicated configuration parameters please refer to the User Manual
of each IP-PBX.
3.1 Basic Configuration Parameters
The screenshots below show the main parameters, which should be configured on the
NEC SV8100 IP-PBX in order to operate with the AudioCodes Mediant E-SBC. Standard
Trunk routing or ARS/F-Route can be used to select the SIP trunks for outgoing calls.
DID/DDI Routing is used for incoming calls.
To configure NEC IP-PBX:
1. Connect to the NEC IP PBX using the PC Pro Configuration tool and download the
current configuration.
Figure 3-1: Blade Configuration of NEC SV8100 Viewed in PC Pro
Note: Save your current configuration file before proceeding.
To Next Page
Loading...
