NEC SV8100 - Step 11: Configure Registration Accounts

Configuration Note 4. Configuring AudioCodes E-SBC
Version 7.0 61 AudioCodes Mediant E-SBC
4.11 Step 11: Configure Registration Accounts
This step describes how to configure SIP registration accounts. This is required so that the
E-SBC can register with the BroadCloud SIP Trunk on behalf of IP-PBX. The BroadCloud
SIP Trunk requires registration and authentication to provide service.
In the interoperability test topology, the Served IP Group is IP-PBX IP Group and the
Serving IP Group is BroadCloud SIP Trunk IP Group.
 To configure a registration account:
1. Open the Account Table page (Configuration tab > VoIP menu > SIP Definitions >
Account Table).
2. Enter an index number (e.g., "0"), and then click Add.
3. Configure the account according to the provided information from , for example:
Parameter Value
Application Type
SBC
Served IP Group
IP-PBX
Serving IP Group
BroadCloud
Username As provided by BroadCloud
Password As provided by BroadCloud
Host Name
interop.adpt-tech.com
Register
Regular
Contact User
8325624857 (pilot number)
4. Click Apply.
Figure 4-37: Configuring SIP Registration Account