NEC SV8100 - Step 1 B: Configure Network Interfaces

AudioCodes Mediant E-SBC 24 Document #: LTRT-12530
NEC SV8100 IP-PBX & BroadCloud SIP Trunk
4.1.2 Step 1b: Configure Network Interfaces
This step describes how to configure the IP network interfaces for each of the following
interfaces:

LAN VoIP (assigned the name "Voice")

WAN VoIP (assigned the name "WANSP")
 To configure the IP network interfaces:
1. Open the IP Interfaces Table page (Configuration tab > VoIP menu > Network > IP
Interfaces Table).
2. Modify the existing LAN network interface:
a. Select the 'Index' radio button of the OAMP + Media + Control table row, and
then click Edit.
b. Configure the interface as follows:
Parameter Value
IP Address
192.168.100.15 (IP address of E-SBC)
Prefix Length
24 (subnet mask in bits for 255.255.255.0)
Default Gateway
192.168.100.254
VLAN ID
1
Interface Name
Voice (arbitrary descriptive name)
Primary DNS Server IP Address
192.168.100.254
Underlying Device
vlan 1
3. Add a network interface for the WAN side:
a. Enter 1, and then click Add Index.
b. Configure the interface as follows:
Parameter Value
Application Type
Media + Control
IP Address
82.153.203.53 (WAN IP address)
Prefix Length
25 (for 255.255.255.128)
Default Gateway
82.153.203.49 (router's IP address)
VLAN ID
2
Interface Name
WANSP
Primary DNS Server IP Address
82.153.203.49
Secondary DNS Server IP Address
8.8.8.8
Underlying Device
vlan 2
4. Click Apply, and then Done.