AudioCodes Mediant E-SBC 26 Document #: LTRT-12530
NEC SV8100 IP-PBX & BroadCloud SIP Trunk
4.2 Step 2: Enable the SBC Application
This step describes how to enable the SBC application.
To enable the SBC application:
1. Open the Applications Enabling page (Configuration tab > VoIP menu >
Applications Enabling > Applications Enabling).
Figure 4-4: Enabling SBC Application
2. From the 'SBC Application' drop-down list, select Enable.
3. Click Submit.
4. Reset the E-SBC with a burn to flash for this setting to take effect (see Section 4.13 on
page 63).
To Next Page
Loading...
