NEC SV8100 - Step 13: Reset the E-SBC

Configuration Note 4. Configuring AudioCodes E-SBC
Version 7.0 63 AudioCodes Mediant E-SBC
4.13 Step 13: Reset the E-SBC
After you have completed the configuration of the E-SBC described in this chapter, save
("burn") the configuration to the E-SBC's flash memory with a reset for the settings to take
effect.
 To save the configuration to flash memory:
1. Open the Maintenance Actions page (Maintenance tab > Maintenance menu >
Maintenance Actions).
Figure 4-39: Resetting the E-SBC
2. Ensure that the 'Burn to FLASH' field is set to Yes (default).
3. Click the Reset button.