218
6. The previous steps allow the phone to connect the Wi-Fi network with DHCP setting by default. If it
needs to be connected the Wi-Fi with static IP settings, please scroll down the setting window and tap
to check the “Advanced options”. Then the window will show up the IP settings at the bottom. If the
Static is selected, the system will require end user to input IP address, Gateway, Network prefix length
and DNS 1 and DNS 2 addresses.
Figure 283: GT890 Connect to Wi-Fi-Show Advanced Options
7. If there is a need to modify the saved Wi-Fi network setting, tap and long press the SSID bar in the Wi-
Fi setting page. The system will pop up a prompt and then you need to tap on “Modify network”. Then,
the phone system will pop up a new window to allow user to check the Wi-Fi parameters and change
the setting by checking the “Advanced options” at the bottom.
8. You can also add Wi-Fi Networks manually if the network is hidden or not showing on the list of scanned
SSIDs. You need to roll down the Wi-Fi settings page and tap on “Add network” and then enter the
SSID name, Security type and Password.
To Next Page
Loading...
