22
Connecting and Setting Up the GT890
The GT890 can be installed using the built-in stand or attached on the wall using the slots for wall mounting.
Figure 6: Built in Stand and Mounting Slots on GT890
Figure 7: GT890 Back / Side View
Using the Phone Stand
The GT890 has a built-in phone stand. To set up the GT890 as your desk phone, follow the steps below:
1. Take the phone stand out on the back and adjust the angle to place the phone steady on the desk;
2. Connect the handset and main phone case with the phone cord;
3. Connect the LAN port of the phone to the RJ-45 socket of a PoE Switch or a router (LAN side (PoE) of
the router) using the Ethernet cable.
The LCD will display the booting up screen or firmware upgrading information. Before continuing,
please wait for the main screen display to show up.
4. Using the web configuration interface or from the menu of the touch screen, you can further configure
network connection using static IP, DHCP etc.
To Next Page
Loading...
