Issue 7.00
3 - 374 Programming
Dial Action Table 1 enables the following usage:
Dial system extensions (if installed) 200~299 & 300~399.
Dial 0 for an operator (extension 200).
Dial * + Extension to leave a Quick Message in a mailbox.
Dial # + Extension to remotely log on to their mailbox.
Wait on the line to be automatically routed to the operator.
Programming
1. Set up trunks as DILs.
22-02-01 Incoming Call Trunk Setup
Assign Service Type 4 to each trunk you want to be a DIL. Make a separate
entry for each Night Service mode.
Assign Service Type 3 to each trunk you want to be a DID. Make a separate
entry for each Night Service mode.
. By default, trunks are Service Type 0 (Normal).
2. Have the DILs terminate to InMail extension.
22-07-01 DIL Assignment
For each trunk you designate as a DIL, enter the InMail group pilot number.
Make a separate entry for each Night Service mode.
. By default, there are no DIL destinations programmed.
22-11 DID Assignment
For the required incoming digits, enter InMail pilot number in 22-11-02 or
102 (Voice mail routing) in 22-11-05 or 06 . Make a separate entry for each
Night Service mode configured.
To Next Page
Loading...
