– 46 –
CHAPTER 5 Various Settings of PCPro
Note 1: The Cancel button is displayed only when the [Add] button is clicked. However, it is invalid if there is no
connection account registered.
Note 2: Before setting the [Connection Account Setting], set the following setting.
- Modem Setting on PCPro side
- Modem Setting on IOC side
No. Item Description
(1) Connection Accounts List
Displays a list of connection accounts registered on PCPro. When
one of the connection account is selected from the list, the regis-
tered data is displayed in the item (4) - (8)
and can be edited.
(2) [Add...] button
Click to add an additional connection account. The item (4) - (8)
are initialized, and a new data can be edited.
(3) [Remove] button
Click to delete the connection account selected from the Connec-
tion Accounts list.
(4) Account Name
Enter the name of the connection account.
A maximum of 16 characters can be registered except the [\ / : , . ;
* ? “ < > |] and a space.
(5) FUG Select the fusion group number of the system from 0-4. (default: 0)
(6) FPC Enter the fusion point number of the system from 0-253.
(7) Connection Type
Select the connection type with the system from the following.
• TCP/IP *default
• Serial (Direct)
• Serial (Dial-up)
(8)
TCP/IP
IP Address
Enter the IP address of the system from [0.0.0.0 -
255.255.255.255].
Port Number Enter the port number of the system from [0-65535].
Serial (Direct)
COM Port
Select the serial port used to connect with the system from COM1-
4. (default: COM1)
Speed (bps)
Select the speed to communicate between PCPro and the system
from [300/600/1200/2400/4800/9600]. (default: 4800)
Serial (Dial-up)
Note 1
Modem Name
Select or enter the name of modem used to connect with the sys-
tem. The modem port installed on the PC is displayed as an option.
Also, a maximum of 50 characters can be entered.
Phone Number
Enter the telephone number to connect with. A maximum of 50
characters can be entered only from the [0-9 * # - ( ) ,].
(9) [Setup] button Click to setup the edited connection account.
(10) [Cancel] button Note 1 Click to cancel the edit.
(11) [Close] button Click to close the [Connection Account Setting] screen.
To Next Page
Loading...
