NEC Univerge SV9100 - Power Requirements; Power Supply Specifications

Issue 2.0
SV9100 General Description Manual 5-21
SECTION 5 POWER REQUIREMENTS
A dedicated 100VAC/120VAC/220VAC/230 – 240VAC 50Hz/60Hz circuit located
within seven feet of the chassis is required. A separate dedicated outlet for each
chassis should be installed.
5.1 Power Supply Specifications
AC Power Supply:
 Dedicated 15 Amp circuit
 Power Requirements: 120 VAC @ 15A Controlling/Base Chassis
LCA Twisted Pair
600 ohms (Including the SLT)
3,281 ft (1,000m) with 26 AWG
4,920 ft (1,500m) with 24 AWG
8,202 ft (2,500m) with 22 AWG
OPX Twisted Pair
1,500 ohms or less (Including the SLT)
13,123 ft (4,000m) with 26 AWG
20,997 ft (6,400m) with 24 AWG
14,777 ft (10,600m) with 22 AWG
 Mixing digital and analog ports through the same 25-pair cable runs is not
recommended.
Table 5-18 Cabling Requirements
Connected Equipment Cable
Music on Hold and Background Music Sources Hi-Fi Shielded Audio Cable
External Amplifier Hi-Fi Shielded Audio Cable
ITL Cabling Cat 5 Straight Data Network Cable
– 328.1 ft (100m) maximum
distance
IP Video Doorphone Maximum 100m (by LAN cable)
Table 5-17 Cable Connection Between Analog Port and Single Line Equipment (Continued)
Connected
Equipment
Cable
Maximum Feet from Connected Equipment
to Telephone
NOTE

Double Pole/Neutral Fusing (power supply fuses are located at both the L
and N side).