NEC Univerge SV9100 - Table 5-8 Board Power Factor; Table 5-9 Maximum Number of Packages Installed

Issue 2.0
5-14 Hardware Specifications
SECTION 2 CHASSIS POWER BASED CALCULATOR CHART
The Univerge SV9100 system uses two types of power factors. For a single chassis
chart refer to Table 5-8 Board Power Factor. For the maximum number of specific
blades per package, see Table 5-9 Maximum Number of Packages Installed. Refer to
Table 5-10 Terminal Power Factor on page 5-15 for the Terminal/ Adapter power
chart. Refer to Table 5-11 IP Terminal Power Factor Chart – DT700 on page 5-16 for
the DT700 IP Terminal Power chart or Table 5-12 IP Terminal Power Factor Chart –
DT800 on page 5-16 for the DT800. Refer to Table 5-13 IEEE802.af Class
Specifications on page 5-17 for the Class Specifications chart.
Table 5-8 Board Power Factor
Board Power Factor
Total =<7
Item Power Factor
GCD-CP10
1
GCD-VM00
2
GCD-ETIA
2
GCD-PVAA
1
GPZ-IPLE
2
GCD-SVR2
2
GCD-RGA
1
Table 5-9 Maximum Number of Packages Installed
Board
(Power Factor)
Maximum Number of Package Installed
9.5 inch
with CCPU
19 inch with
CCPU
19 inch
without
CCPU
4 x 19 inch
GCD-ETIA (2)
23312
GCD-PVAA (1)
25623
GCD-SVR2
22311
GCD-RGA (1)
1111