NEC Xen Topaz - Page 204

Chapter 4 - 196 Features
NEC Business Solutions Ltd XEN Topaz
Doc. No. 8846 - Release 2.0 April 2005
Conditions
A. When Program 10-03-03 is changed between Point-Multipoint and Point-Point,
the Topaz
system must be reset (switch off then on again) before the service will operate.
Default Setting
Connection Type = Point-Multipoint.
• Programming
10-03 : : System Configuration Setup – PCB Setup (BRIU)
Setup the Basic Configuration data for the BRI ISDN card ,as follows:
10-03-01 : ISDN Line Mode (T-Point, S-Point, S-Point Leased Line).
10-03-02 : Logical Port Number.
10-03-03 : Connection Type (Point-Multipoint, Point-Point).
10-03-04 : Layer 3 Timer Type (1-5).
10-03-05 : CLIP Information Announcement (Disable, Enable).
Based on this setting, the system will include a “Presentation
Allowed” (1) or “Presentation Restricted” (0) in the Setup
message to allow or deny the Calling Party Number. Pro-
gram 15-01-04 must also be set to a ‘1’ if this option is
enabled.
10-03-06 : S-Point Connection Mode (Extended Passive Bus, Short
Passive Bus).
10-03-07 : S-point DID digits (0-4).
10-03-08 : Dial Sending Mode (Enbloc sending, Overlap sending).
10-03-09 : Dial Information Element (Overlap Sending Mode) (Keypad
Facility, Called Party Number).
If Overlap Sending is selected in Program 10-03-08, select
either Keypad Facility (0) or Called Party Number (1) for the
dial information element.
10-03-14 : S-Point Service Protocol (Keypad facility, Special Protocol for
Topaz system).
10-06 : System Configuration Setup – ISDN BRI Setup
Specify the TEI selection and DID mode for DID callers when the BRI
feature is used.
10-06-01 : TEI selection (Select by SPID number, Select by Channel ID
Number).
10-06-02 : DID mode (Route by Called Party Number, Route by Redi-
recting Number).
10-06-03 : SPID1 (Up to 20 digits).
10-06-04 : SPID2 (Up to 20 digits).
15-01-04 :Basic Extension Data Setup – Calling Party Number Notification
(ISDN Caller ID)
If both Program 15-01-04 and 10-03-05 are enabled (1), the system
includes Caller ID in the Setup message as “Presentation Allowed”. If
these options are disabled (0), it will be “Presentation Restricted”.
15-07-01 :Programmable Function Keys