XEN Topaz NEC Business Solutions Ltd
Features and Specifications Manual Chapter 4 - 197
Doc. No. 8846 - Release 2.0
April 2005
Assign a Programmable Function Key for Caller ID Block for ISDN
(Function Number 63), if required, to restrict the sending of Caller ID on
outgoing calls.
20-06-01 :Class of Service for Extensions
Assign a Class of Service (1-15) to an extension.
20-13-23 :Class of Service Options (Supplementary Service) - Display the
Reason for Transfer
Enable (1) or disable (0) an extension’s ability to display the reason (Call
Forward, Busy, No Answer or DND) a VRS, DID, DISA, or ISDN call is
being transferred to their extension.
20-08-13 :Class of Service Options (Outgoing Call Service) - ISDN CLIP
Determine if the ISDN calling line identity presentation and screening
indicators are to be allowed (0=disabled, 1=enabled).
20-25 : System Option Setup – ISDN Options
Define the ISDN system options for the BRI ISDN card ,as follows:
20-25-01 : Send Release Message After Subscriber Hang Up
20-25-02 : Progress Indicate Information element detect
20-25-03 : Bearer Capability select from SLT Outgoing (3.1kHz Audio,
Speech)
20-25-04 : Send DT Until User Dials the First Digit (Overlap Sending
Mode)
20-25-05 : T305 Timer Start After Sending Disconnect Message
20-25-06 : Call Proceeding Send Mode
20-25-07 : Busy Tone Mode Set When Disconnect Message Received
20-25-08 : Use of Low Layer Compatibility (LLC)
20-25-09 : Use of High Layer Compatibility (HLC) Sending
20-25-10 : S-Point Terminal Seizes Analogue Trunk
20-25-11 : Automatic Changing System Clock When Date/Time Infor-
mation Element Received
20-25-12 : Forwarded Incoming Calls Return Connect Message when
Outgoing Call Receives Alert Message
20-25-13 : Use busy tone when trunk call receives Release Message
21-08-04: Time for Send Busy Tone for ISDN Trunk
Set the timer to send out Busy Tone on an ISDN line, when the called
party is busy (0-64800sec).
21-12 : Outgoing Call Setup – ISDN Calling Party Number Setup for Trunks
Assign Calling Party Numbers for each trunk (maximum 16 digits per
entry). When a call is made by an extension which does not have an
Extension Calling Number assigned (Program 21-13), the system sends
the calling number for the ISDN trunk defined in Program 21-12. Note:
If the Calling Party Number is assigned in both Programs 21-12 and 21-
13, the system sends the data in Program 21-13.
21-13 : Outgoing Call Setup – ISDN Calling Party Number Setup for Exten-
sions
To Next Page
Loading...
