Necta brio 3 - Technician Menu - Selections; 2.2.1 Setting Water Doses; 2.2.1.2 Setting Whipper Parameters

P2595EN01
08 - 2007

15
2.2 - SELECTIONS
2.2.1 - SET WATER
2.2.1.1 - WATER DOSES
2.2.1.2 - SET WHIP DOSES
2.2.1.2.1 - SET DOSES
2.2.1.2.2 - SET MODALITY
2.2
se l e c t I o n s
2.2.1
se t t I n g t h e w a t e r
2.2.1.1
wa t e r d o s e s
With this function the water doses that compose the drink can be
set for each selection button.
These are expressed in:
- cc for instant products;
- fmp (number of pulses of the volumetric counter) for Espresso
(coee or tea).
The display will indicate the number of the water dose being set
(water 1, water 2, etc.) and the water value blinking. In order to verify
the correspondence between the water doses refer to the “Selection
dose table”.
2.2.1.2
s
e t t I n g t h e w h I P P e r
2.2.1.2.1
se t t I n g t h e w h I P P e r d o s e s
The whipping time can be set for each selection button, for each
water dose that composes such selection.
The duration can be set in two dierent modes:
2.2.1.2.2
s
e t t I n g t h e w h I P P e r m o d e
It is possible to choose between two dierent modes:

i.e. independent from the solenoid valve opening time. The whip-
ping duration is set as tenths of a second for Instant models and as
volumetric counter pulses for Espresso models.

i.e. based on the dierence, plus or minus, from the moment the
solenoid valve closes.
The whipping duration is always expressed in tenths of a second.