P2595EN01
08 - 2007
16
2.2.1.3 - SOLENOID SETTING
2.2.1.4 - DRIPPING TIME
2.2.2 - SET POWDER
2.2.2.1 - POWDER DOSES
2.2.2.2 - DOSER SETTINGS
2.2.3 - SET ACCESSORIES
2.2.3.1 - ENABLE CUP
2.2.1.3
so l e n o I d v a l v e s e t t I n g s
It is possible to set the water ow rate of the single solenoid valves
expressed in cc/s (the default value setting in cc/s is indicated in
the selection dose table) to calculate the amount of water to be
dispensed.
2.2.1.4
s
e t dr I P P I n g tI m e
The wait time (programmable from 0 to 2000 hundredths of a sec-
ond) to the emission of an “end of dispensing” warning sound can
be set for each selection in order to allow the tubes to drain.
2.2.2
s
e t t I n g t h e P o w d e r s
2.2.2.1
Po w d e r d o s e s
This function is used for setting, for each selection button, the in-
stant product powder doses that compose the drink.
These are expressed in gr. (grams).
The display will indicate the combination of water and powder being
set (water 1 - powder 1, etc.) and the powder dose value blinking.
In order to verify the correct correspondence refer to the “Selection
dose table”.
2.2.2.2
s
e t t I n g t h e d o s e r u n I t s
This function is used for setting the ow rate of the single doser
units, expressed in g/s, to calculate the amount of powder to be
dispensed, for correct conversion of product dose values.
2.2.3
s e t t I n g t h e a c c e s s o r I e s
2.2.3.1
e n a b l I n g t h e c u P
This function is used for enabling or disabling cup dispensing for
each selection button.
To Next Page
Loading...
