Installation and Configuration | AEOS Blue and vehicle identification EN
Manual version 3 41/48
6. ANPR LUMO via Serial
6.1 Configuring the ANPR LUMO reader
When the ANPR LUMO reader is correctly mounted and connected (see the ANPR LUMO Install
Guide), the next step is to configure it to send the license plate number string to the AEOS blue
controller.
To configure the ANPR LUMO reader, take the following steps:
Configure the ANPR LUMO reader
1. Log in to the NEDAP ANPR LUMO software.
2. Go to
CONFIGURATION > ACTIONS > READ.
3. Click
ADD and select SERIAL.
To Next Page
Loading...