Nedap AEOS Blue - Page 45

Installation and Configuration | AEOS Blue and vehicle identification EN
Manual version 3 45/48
9. Right-click the StandardDoor AEbc, and click Properties.
10. Set the
Primary Identifier type to Generic▼, and adjust the Input Settings parameters as
shown below:
Input Settings
Value
AEserver Settings
Value
Sub type
0
Identification type
AlphaNumeric
Data type filter
Cleared
Identifier length
0
Format
Ascii-AlphaNumeric▼
Identifier minimum value
Badge number
Identifier maximum value
Bit position
0
Sub type
0
Length
0 bytes
Customer code type
AlphaNumeric
Customer code
Customer code length
0
Fixed code
Cleared
Format
Ascii-AlphaNumeric▼
Bit position
0
Length
0 bytes
Target Identifier
Type
Generic▼
Reverse bytes
Cleared
The identifier type settings must match the settings in AEOS, see section 6.3.
11. Press CTRL+E and click Yes to deploy the configuration.
12. Close AEmon.
Configuration example