Nedap uPASS REACH - Installation; 2.1 Safety Instructions; 2.2 Mounting Instructions; 2.3 Adjustable Mounting Bracket

UPASS REACH | INSTALLATION GUIDE
Content
2/35
CONTENT
1 INTRODUCTION _______________________________________________________ 4
1.1 OVERVIEW _____________________________________________________ 4
1.2 TRANSIT COMPATIBILITY __________________________________________ 4
1.3 SUPPORTED TAGS _______________________________________________ 5
1.4 TAG SECURITY __________________________________________________ 5
2 INSTALLATION ________________________________________________________ 6
2.1 SAFETY INSTRUCTION ____________________________________________ 6
2.2 MOUNTING INSTRUCTIONS _______________________________________ 6
2.3 ADJUSTABLE MOUNTING BRACKET _________________________________ 7
2.4 OPENING THE SERVICE COVER ____________________________________ 8
3 CONNECTIONS ________________________________________________________ 9
3.1 CABLE CONNECTIONS ____________________________________________ 9
3.2 WIRE CONNECTIONS ____________________________________________ 10
3.3 POWER SUPPLY ________________________________________________ 10
3.4 COMMUNICATION ______________________________________________ 11
3.4.1 WIEGAND / MAGSTRIPE CONNECTION _______________________ 11
3.4.2 WIEGAND TIMING ________________________________________ 12
3.4.3 MAGSTRIPE TIMING _______________________________________ 12
3.4.4 RS232 CONNECTION _____________________________________ 13
3.4.5 RS422 CONNECTION _____________________________________ 14
3.4.6 USB CONNECTION ________________________________________ 15
3.5 DIGITAL I/O ____________________________________________________ 16
3.5.1 RELAY OUTPUT __________________________________________ 16
3.5.2 READ DISABLE INPUT _____________________________________ 17
3.5.3 GENERAL PURPOSE INPUTS ________________________________ 17
3.5.4 TAMPER SWITCH _________________________________________ 18
4 DIP SWITCH SETTINGS _________________________________________________ 19
4.1 COMPATIBILITY MODE (SW1-1) ___________________________________ 19
4.2 RS232 / RS422 SELECTION (SW1-2) _______________________________ 19
4.3 ENABLE TESTMODE (SW1-3) _____________________________________ 20
4.4 ENABLE / DISABLE BUZZER (SW1-4) _______________________________ 20
5 LED INDICATIONS ____________________________________________________ 21
6 UHF FREQUENCIES____________________________________________________ 22
6.1 RADIO REGULATIONS ___________________________________________ 22
6.2 FREQUENCY CHANNEL SELECTION ________________________________ 22
7 READER CONFIGURATION ______________________________________________ 23
7.1 UHFTOOL SOFTWARE ___________________________________________ 23
7.2 SETTINGS _____________________________________________________ 23
7.2.1 READ DATA______________________________________________ 23
7.2.2 DECODE NEDAP XS _______________________________________ 24
7.2.3 RELAY / TIMING __________________________________________ 25
7.2.4 LED CONTROL ___________________________________________ 26
7.3 EXPERT SETTINGS ______________________________________________ 26
7.3.1 OUTPUT ________________________________________________ 26
7.3.2 OUTPUT MESSAGE FORMAT ________________________________ 27
7.3.3 EXTRA OUTPUT __________________________________________ 27
7.3.4 FREQUENCY _____________________________________________ 29
7.3.5 READ RANGE ____________________________________________ 29
A TECHNICAL SPECIFICATIONS ___________________________________________ 30
B PART NUMBERS ______________________________________________________ 32
C FCC / IC STATEMENT __________________________________________________ 33