Nedap uPASS REACH - Reader Configuration; 7.1 UHFTOOL Software; 7.2 Settings; 7.3 Expert Settings

UPASS REACH | INSTALLATION GUIDE
Installation
7/35
2.3 ADJUSTABLE MOUNTING BRACKET
With the adjustable mounting bracket, the uPASS Reach can be ‘aimed’ at the
desired detection area. It can also be used for mounting the reader to round or
square masts (see appendix 7.3.5B for part numbers).
Figure 4: Adjustable mounting bracket
Once the adjustable mounting bracket is assembled, attach the bracket to the wall or
mast. After that the uPASS Reach can be mounted onto the bracket. The ball and
socket joint can be used to adjust the reader’s orientation. Tighten the hex screw on
top of the joint to fix the correct orientation.
123mm (4.84")
47mm (1.85")
61mm (2.40")
120mm (4.72")
15mm
(.59")
88mm (3.46")
side view
rear view
∅4.5mm
(.17")
Figure 5: Adjustable mounting bracket dimensions (in mm)
Note
Maximum diameter for
round masts 125mm (
4.9
inch
)
Maximum diameter for
square masts 100mm (
3.9
inch
)