Nedap uPASS REACH - DIP Switch Settings; 4.1 Compatibility Mode (SW1-1); 4.2 RS232; RS422 Selection (SW1-2); 4.3 Enable Testmode (SW1-3)

UPASS REACH | INSTALLATION GUIDE
Introduction
4/35
1
INTRODUCTION
The uPASS Reach reader offers long range vehicle identification up to 4 meters using
the latest UHF technology. Based on battery free passive UHF the uPASS Reach
reader
offers a cost effective and enduring solution for parking access.
The system is based on an uPASS Reach reader and an UHF tag. The readers are
installed next to the gate on a maximum height of 2 meters. The reader is the perfect
cure to the problems char
acteristic of prox and it's ideally suited for upgrading those
installations as the reader can easily be installed on a gooseneck with no need for
additional mounting or rewiring.
The reader output allows the access control or parking system to open the ga
te
when authorized without the need to present a badge.
1.1
OVERVIEW
Below a simplified overview of the components in the reader are shown:
Figure
1: uPASS Reach reader overview
1.2
TRANSIT COMPATIBILITY
The uPASS Reach reade
r features a TRANSIT compatible mode. In this mode the
reader communicates fully compatible with the NEDAP TRANSIT, supporting any
firmware version developed for the TRANSIT reader, including P61, P81 and Q70.
See chapter
4.1 for details how to enable the TRANSIT compatible mode.
Figure
2: uPASS Reach reader overview in TRANSIT compatible mode
Note:
The TRANSIT compatible
mode only works in
combination with NEDAP
UHF XS formatted tags!!!
O123
UHF processor
UHF antenna
Wiegand/Magstripe
UART
USB
RS232
RS422
Auto detect USB
SW1-2
RELAY OUT
READ DISABLE
POWER SUPPLY
UART
USB
RS232
RS422
UHF processor
UHF antenna
Wiegand/Magstripe
UART
Auto detect USB
SW1-2
Only NEDAP UHF XS
formatted tags
RELAY OUT
POWER SUPPLY
TRANSIT
compatible
processor
O123
O123
RELAY OUT
READ DISABLE