Nedap uPASS REACH - Opening the Service Cover

UPASS REACH | INSTALLATION GUIDE
Installation
8/35
2.4 OPENING THE SERVICE COVER
The service cover can be opened to access the connections (including the USB
connector), setup the operating frequency and view the LED indicators.
Open the screws on the bottom of the device to unlock the service cover. Once the
service cover is unlocked, lift it off.
Figure 6: Opening the service cover
Note
Make sure the screws are
completely opened (and
closed when placing the
cover back on). Don’t worry
about losing the screws,
they cannot fall out.