EasyManuals Logo

Nelson 8300 Series User Manual

Nelson 8300 Series
169 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
PROGRAMMING INSTRUCTIONS
Programming Overview
The EZ Pro
Jr. can be programmed under AC power or powered from the two
AA alkaline batteries. Before programming the EZ Pro
Jr., it may be helpful to
become familiar with some general programming guidelines:
If a segment(s) on the LCD is flashing, it means that it can be changed by
the user.
When using keys, hold the button three seconds to start a fast scroll.
Be sure the appropriate program letter is displayed when you are
programming; program changes are specific to the program letter
displayed on the LCD.
There is no “ENTER” key. Key-presses and dial settings are stored
automatically for you.
If you make a programming change while a program is running, the
program terminates immediately. The new program starts at the next start
time scheduled.
When not running, the controller displays the current time and the current day.
During manual operations, there is a 5-second delay before the operation
begins. During this time, you can change your settings. Each time you
make a change, the delay resets to 5 seconds.
MANUAL and CYCLE procedures only operate with the Program dial set in
the AUTO position.
After a test procedure runs, the controller reverts back to the AUTO
procedure and runs the next program scheduled.
The test procedures ignore the sensor connection; this allows you to
water or run your program even if the sensor has suspended operation.
To clear all programs and start over, press and hold SELECT ‘–’ and
ADJUST ‘–’ for three seconds
11

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Nelson 8300 Series and is the answer not in the manual?

Nelson 8300 Series Specifications

General IconGeneral
BrandNelson
Model8300 Series
CategoryController
LanguageEnglish

Related product manuals