PROGRAMMING INSTRUCTIONS - PROGRAM MODE
Set Event Days Programming (Optional)
Turn the large dial to the SCHEDULE position. The last scheduling option
chosen for the current program appears on the LCD. Press both the SELECT ‘+’
and SELECT ‘–’ together. A flashing indicator will appear next to Event Days on
the LCD. Use the ADJUST ‘+’ button to select that day for watering or press
ADJUST ‘–’ for non watering days. A flashing indicator appears over the day
you’re about to set. Raindrops appear over selected days to water. The
indicator automatically moves one day to the right after an ADJUST ‘+’ or ‘–’
key press. Continue selecting or deselecting the days you want the controller to
water until you have your 7 day calender set.
NOTE: Programming an EVENT DAYS schedule does NOT delete any other
schedule for the selected program.
Repeat the above procedures for each program (A, B, or C), as you require.
That’s it! Your EZ Pro
™
Jr. is now programmed. Turn the MODE dial to the
AUTO position to run the program you entered.
PROGRAM REVIEW
To review the current program, turn the MODE dial to the PROGRAM position
and turn the large dial to the setting you wish to review (i.e., turn the large dial
to TIME to review the time set for the controller). When you need to view
different zones or run times (1, 2, 3), use the SELECT buttons only.
NOTE: Since you are in the program mode, the potential exists to change
the program accidentally.
19
To Next Page
Loading...
Need help?
General
