ADVANCED FEATURES - AUTO MODE
The EZ Pro
™
Jr. incorporates two manual/test procedures for checking the
function of the controller or allowing you to bypass the current program to
water immediately. The following section will show you how to set up the
controller to:
• Run a zone manually
• Run a program manually
NOTE: All test procedures are run with the MODE dial in the AUTO position.
This allows the controller to reset to the AUTO setting after running a
manual/test procedure. It also allows you the ability to walk away
from the controller after setting up a manual/test procedure and not
have to come back to reset the controller to AUTO.
NOTE: All manual/test procedures ignore the sensor connection. Therefore,
you can water utilizing one of the manual/test procedures even if the
sensor has suspended your scheduled program.
Run a Zone Manually
Turn the large dial to the MANUAL position. The default of zone 01 and 00:10
minutes will be flashing (recall that this means you can change them). Press
SELECT to select the zone number that you want to run. Press ADJUST to set
the run time for the selected zone. The controller will delay 5 seconds before
starting the zone.
22
To Next Page
Loading...
Need help?
General
