PROGRAMMING INSTRUCTIONS
Front Panel Layout
Looking at the front panel (see figure 3), you see a large LCD, 4 rubber
buttons, one large rotary dial, and two small rotary dials. The rubber buttons
are marked SELECT and ADJUST and are the core of Nelson’s exclusive
SELECT&ADJUST
™
programming. The keys are identified with ‘+’ or ‘–’ for
increasing or decreasing the segment you’re working on.
SELECT&ADJUST
™
works on the principle that you first SELECT what you
want to set, and ADJUST the variables of what you selected. For example, if
you want a run time of 10 minutes on zone 5, you would use the SELECT keys
to select zone 5 and, once on zone 5, you would use the ADJUST keys to set
the run time to 10 minutes.
There are instances when only SELECT or only ADJUST are required. They will
be explained in this guide where appropriate.
12
To Next Page
Loading...
