FCC COMPLIANCE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and the receiver.
● Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
● Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance may void the user’s authority
to operate the equipment.
SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
Users of these documents are cautioned to familiarize themselves with safety instructions contained in this section and
observe at all time when working.
Users are reminded that all electrical or electronic devices come with residual risks despite compliance with international
safety requirements and careful construction. To prevent injury and property damage, and to ensure long-term operation
of the product, please adhere to all applicable safety instructions in handling and usage of the product.
Danger to life due to electrical shock when live components are touched in opened product
High voltages and energies are present in live components and cables inside the product during operation, e.g.
capacitors, connectors. Touching live components and cables may result in death or severe injuries due to electric
shock.
DO NOT open the product.
DO NOT touch live components.
Danger to life due to electrical shock when live DC cables or components are touched
High DC voltages are present in the DC cables when PV modules are exposed to light. Touching live DC cables or
components may result in death or severe injuries due to electric shock.
DO NOT touch non-insulated parts or cables.
DO NOT touch live components when voltage sources are still connected or just disconnected.
DO NOT connect DC connectors to the product under load.
Personal protective equipment MUST be worn suitably and properly for all work on the product and the
system.
Voltage sources MUST be disconnected from the product before all work.
To Next Page
Loading...
