CLEAR MEMORY
Enter P96E when in Installer Program mode to clear all events in the Alarm memory
display.
Note: This option clears only the 20 event memory as read by KPX and LCD keypads.
Ness Navigator touch screen keypad's 80 event memory is not affected.
PROGRAMMING SEQUENCE:
P96E Clears Alarm Memory display
P96E
PROGRAM MODE LEVEL
Installer mode or NessComms.
FACTORY DEFAULT
[not applicable]
CLEAR PANEL OPTIONS
Defaults all program options except User Codes and Radio Codes.
Note, this option will also delete Radio Devices programmed on zones.
PROGRAMMING SEQUENCE:
P97E Restores Factory Defaults
P97E
PROGRAM MODE LEVEL
Installer mode or NessComms.
FACTORY DEFAULT
[not applicable]
NOTES
Note, this option will also delete Radio
Devices programmed on zones.
CLEAR USER CODES
This option clears all User Codes, (this means all Keypad Codes, Radio Keys and
Access cards) and restores User Code 1 to the factory setting of 123.
P201E – P256E are defaulted (User Codes 1–56)
PROGRAMMING SEQUENCE:
P98E Clears User Codes
P98E
PROGRAM MODE LEVEL
Installer mode or NessComms.
FACTORY DEFAULT
User Code 1: 123
All other codes: [blank]
NOTES
Installer Code.
CLEAR RADIO DEVICES
This option clears all Radio Devices assigned to zones 1–8 or 1–16.
(This option does not clear User Codes).
PROGRAMMING SEQUENCE:
P95E Clears Radio Device Codes
P95E
PROGRAM MODE LEVEL
Installer mode or NessComms.
FACTORY DEFAULT
[not applicable]
These options allow selective restoring
of various factory defaults. For example,
you can default (clear) all the User
Codes, without affecting any other
programmed options.
PROGRAM THE INSTALLER CODE
Programs the installer code. This code can be 3 to 6 digits long. Factory default
installer code is 000000.
PROGRAMMING SEQUENCE:
P99E [Enter new code]E [Enter new code again]E
(Unlike User Codes, the installer code is not displayed when programming)
P99E
PROGRAM MODE LEVEL
Installer mode or NessComms.
FACTORY DEFAULT
000000
For a complete list of factory default values, see the
Programming Options Summary on pages 86–91.
Option No. Description
P95E CLEAR RADIO DEVICES
P96E CLEAR MEMORY
P97E CLEAR PANEL OPTIONS (RESTORE FACTORY DEFAULTS)
P98E CLEAR USER CODES
P99E PROGRAM INSTALLER CODE
53
NESS D8X / D16X DELUXE CONTROL PANEL – INSTALLATION MANUAL
PROGRAMMING
To Next Page
Loading...
