Table 8: Supported routers
Vendor Model Speed
Cisco 9222i 8Gb
Brocade 7800 8Gb
Qlogic 6240 8Gb FC
10 Gb iSCSI
6250 10 GbE iSCSI
6260 8Gb FC
10 Gb iSCSI
Contact technical support for the latest information about new switches that are tested and certified to
work with various hardware and software combinations.
Procedure - Installing and configuring switches
Steps
1. Install your switch according to the vendor’s documentation.
2. Contact technical support to obtain this information:
• The latest hardware compatibility information
• The models of the switches that are supported
• The firmware requirements and the software requirements for the switches
3. Update the switch’s firmware from the
NetApp Interoperability
site.
This update might require that you cycle power to the switch.
30 | E2700 Controller-Drive Tray and Related Drive Trays Installation Guide
To Next Page
Loading...
Need help?
General
