Note: See "10/25-GbE port connections for the E5700SG controller" for more information about the options for
these ports.
Information needed Your value
Network bond mode Choose one:
• Active-Backup (default)
• LACP (802.3ad)
VLAN tagging enabled Choose one:
• No (default)
• Yes
VLAN tag
(if VLAN tagging is enabled)
Enter a value between 0 and 4095:
DHCP-assigned IP address for the Grid Network, if
available after power on
Note: If the Grid Network includes a DHCP server, the
E5700SG controller displays the DHCP-assigned IP
address for the Grid Network on its seven-segment
display after it boots up.
• IPv4 address (CIDR):
• Gateway:
Static IP address you plan to use for the appliance
Storage Node on the Grid Network
Note: If your network does not have a gateway, specify
the same static IPv4 address for the gateway.
• IPv4 address (CIDR):
• Gateway:
Grid Network subnets (CIDR)
Note: If the Client Network is not enabled, the default
route on the controller will use the gateway specified
here.
Table 5: Information needed to connect the E5700SG controller to the Client Network
The Client Network for StorageGRID is an optional network, typically used to provide client protocol access to the
grid. The appliance connects to the Client Network using the 10/25-GbE ports on the E5700SG controller.
Note: See "10/25-GbE port connections for the E5700SG controller" for more information about the options for
these ports.
Information needed Your value
Client Network enabled Choose one:
• No (default)
• Yes
Network bond mode Choose one:
• Active-Backup (default)
• LACP (802.3ad)
Hardware Installation and Maintenance Guide for SG5700 Appliances 19
Preparing for installation
To Next Page
Loading...
Need help?
General
