NetComm Wireless AC1200 WiFi Gigabit Router with Voice
The following codecs are available for use:
G.711 a-law
G.711 u-law
G.726 -32
Set the codec you would like to try first with your VoIP service.
Set the codec you would like to try second with your VoIP service.
Set the codec you would like to try third with your VoIP service.
Set the codec you would like to try fourth with your VoIP service.
Adjust the packet length size. This can reduce or increase the bandwidth required for a VoIP call.
Adjust the ‘Voice Activity Detection’ interval.
This should not be adjusted unless the words in your conversation are being cut off.
(This setting should not need to be changed.)
The packet length for Comfort
noise packet
Set the time in milliseconds for which comfort noise is used to simulate background noise at your
end of the connection.
Click Save to save your settings.
DTMF Setting
The DTMF Setting page enables you to specify which DTMF standard to use on your VoIP service.
Figure 53 - DTMF settings
The following DTMF standards are available for use:
RFC 2833
Inband DTMF
Send DTMF SIP Info
This information will usually be supplied by your VoIP service provider and should not need to be changed unless you are
experiencing issues with DTMF based services
(Automated Telephone services, Answering machines, etc).
Select which DTMF standard you would like to use.
Table 20 - DTMF settings
Click Save to save your settings or Undo to discard the settings entered.
To Next Page
Loading...
