MAC Filter
MAC Filter allows you to add or remove the MAC Address of devices which will be allowed or denied access to the wireless
network. First use the Select SSID drop down list to select the wireless network you wish to configure, then select to either allow or
deny access to the MAC addresses listed.
Click Add to add a MAC Address Filter.
Enter the MAC Address to be filtered and click Apply/Save to save the new MAC Address filter settings.
To delete a MAC filter entry, click the Remove checkbox next to the selected filter entry and click Remove.
Note: While giving a wireless network some additional protection, MAC filtering can be circumvented by scanning a valid
MAC and then spoofing one's own MAC into a validated one, using MAC Filtering may lead to a false sense of security.
Wireless Bridge (Wireless Distribution Service)
Wireless Bridge allows you to configure the router’s access point as a Wireless Distribution Service.
Select the mode for the Wireless Access Point built into the NF17ACV. You can specify which wireless networks will be allowed to
connect to the NF17ACV by using the ‘Bridge Restrict’ option and then entering the applicable MAC Addresses of the other
wireless access points.
Note: WPA/WPA2 encryption may not be compatible with other vendors, when operating in Wireless Bridge (WDS) mode.
Click Apply/Save to save the new wireless bridge configuration settings.
To Next Page
Loading...
Need help?
General
