Click the Install link to the right of the main firmware image you uploaded and then click OK to confirm that you want to
continue with the installation.
Note: Do not remove the power when the router’s LEDs are flashing as this is when the firmware update is in process.
The installation is complete when the countdown reaches zero. The router attempts to redirect you to the Status page.
Figure 132 -– Installing main firmware image
Hold down the reset button on the router for more than 15 seconds (when all LEDs stop flashing) to reboot and restore the
factory default settings of the router. See the Restoring factory default settings section for more information.
To Next Page
Loading...
Need help?
General
