NetComm Wireless NTC-30WV 3G Outdoor Router with Voice
Table 41 - Administration configuration options
To access the router’s configuration pages remotely:
Open a new browser window and navigate to the WAN IP address and assigned port number of the router, for example
http://123.209.130.249:8080
Note: You can find the router’s WAN IP address by clicking on the “Status” menu. The WWAN IP field in the WWAN
Connection Status section shows the router’s WAN IP address.
Enter the username and password to login to the router and click Log in.
Note: To perform functions like Firmware upgrade, device configuration backup and to restore and reset the router to factory
defaults, you must be logged in with the root manager account.
WARNING: Using an insecure password will result in your device being compromised. Any resulting damage may not be
covered under warranty. It is strongly advised that the password not be a dictionary word, nor should the same password
be used across fleets of devices.
Remote router access control
Enable or disable remote HTTP access to the router. You can also set the port you would like remote HTTP access to be available on.
Enter a port number between 1 and 65534 to use when accessing the router remotely.
Enable or disable remote HTTPS access to the router using a secure connection.
Enter a port number between 1 and 65534 to use when accessing the router remotely over a secure HTTPS connection.
Enable or disable remote telnet (command line) access to the router.
Enable or disable Secure Shell on the router.
Enter the port number for remote SSH access. Must be a port number between 1 and 65534.
Enable or disable remote ping responses on the WWAN connection.
Local router access control (Telnet/SSH)
Web User Interface account
Use the drop down list to select the root or admin account to change its web user interface password.
Enter the desired web user interface password.
Re-enter the desired web user interface password.
Displays the Telnet/SSH.username. This may not be changed.
Enter the desired Telnet/SSH password.
Re-enter the desired Telnet/SSH password.