NetComm NTC-30WV

To Next Page

To Previous Page

NetComm Wireless NTC-30WV 3G Outdoor Router with Voice

www.netcommwireless.com

Ver 1.6

Figure 41 - Wireless hotspot configuration

Main Page

Default Chapter3
- Table of Contents3
Overview6
- Introduction6
- Target Audience6
- Professional Installation Instructions6
- Prerequisites7
- Notation7
Product Introduction8
- Product Overview8
- Package Contents8
- Product Features9
Hardware Overview10
- LED Indicators10
- Physical Dimensions12
- Interfaces14
Implementation and Deployment Scenario16
Installation and Configuration of the NTC-30WV17
- Hardware Installation17
- Powering the Router Via DC Power Supply17
- Installing the Router17
- Powering the Router Via a Power over Ethernet (Poe) Cable (Optional)18
  - Captive Power Terminal Block18
- Connecting Wirelessly19
Advanced Configuration20
Status21
- Event Notification22
Networking24
- Data Connection24
- Operator Settings29
  - Operator Settings30
- SIM Security Settings30
- Lan34
  - LAN Configuration34
  - Dhcp35
- Wireless Settings38
- Wireless Distribution System (WDS)46
  - What Is WDS46
  - Configuring WDS46
- Ethernet LAN/WAN51
  - Interface Assignment51
  - WAN Configuration52
- WAN Failover53
  - Link Monitor54
  - Ping Monitor54
- Routing57
- Vpn67
Services81
- Dynamic DNS81
- Network Time (NTP)82
  - Configuring Timezone Settings82
  - Configuring NTP Settings82
- Data Stream Manager83
- Padd92
- Remote Management93
- Auto Dial Configuration99
- Ussd100
- Voice101
- Event Notification102
  - Notification Configuration102
  - Destination Configuration104
- Email Settings105
- SMS Messaging106
- Diagnostics110
  - SMS Diagnostics and Command Execution Configuration110
  - White List for Diagnostic or Execution SMS112
- Sending an SMS Diagnostic Command113
System122
- Log122
- System Configuration126
- Administration131
- Watchdogs139
- Reboot142
  - Logging out142
Appendix A: Tables143
Appendix B: Default Settings145
- Restoring Factory Default Settings146
  - Using the Web-Based User Interface146
  - Using the Reset Button on the Interface Panel of the Router146
Appendix C: Recovery Mode147
- Accessing Recovery Mode147
- Status148
- Log148
- Application Installer149
- Settings149
- Reboot149
Appendix D: HTTPS - Uploading a Self-Signed Certificate150
Appendix E: Obtaining a List of RDB Variables152
Technical Data153
Additional Product Information154
- Using the NTC-30WV to Make and Receive Telephone Calls154
Legal & Regulatory Information158
- Product Warranty159
- Limitation of Liability159
Contact160

NetComm NTC-30WV

Table of Contents

Related product manuals