NETGEAR Arlo Go

10
Set Up Your System
Set Up Your Arlo Go Camera
Use the Arlo app and your Arlo account to set up your Arlo Go camera. If you
already set up an Arlo account, you can add the Arlo Go camera to your account.
During setup, your Arlo Go camera must be connected to the AT&T network.
This requires that you are using a compatible device and a mobile service plan.
Additional restrictions and data charges might apply. Coverage and service are not
available everywhere.
After you add your Arlo Go camera to your Arlo account, you can place the Arlo Go
camera anywhere in AT&T’s network coverage area.
For information about optimizing mobile network connectivity, scan this QR code or
visit tinyurl.com/jyoysqo.
To set up your Arlo Go camera:
1. Place the Arlo Go camera in a location with good cellular network coverage.
2. Make sure that the Arlo Go camera is ready:
• You activated the SIM card.
• The SIM card is inserted in the camera.
3. Tap the Arlo icon
on your mobile device.
If you are using a computer, enter arlo.netgear.com in the address bar of a
browser.
4. If you already set up an Arlo account, log in, and tap or click Add Device.