NETGEAR Arlo Go

42
6. Settings
You can view and change the Arlo Go settings.
View Device Information
¾ To view device information:
1. Tap the Arlo icon
on your mobile device.
You can also enter arlo.netgear.com in the address bar of a browser.
The Devices page displays.
2. Tap or click Settings.
The Settings page displays.
3. Tap or click My Devices.
A list of cameras displays.
4. Tap or click the camera.
The settings for the camera display.
5. Scroll down to the Version heading and view the firmware version, hardware
version, and the serial number.
Turn O the Camera LED and Audio Alerts
The Arlo Go LED indicates the status of the camera. The LED can be useful during
setup and is helpful when you are troubleshooting. You can turn the LED o and
on. We recommend that you wait until your camera is streaming before turning o
the LED.
If you turn o your camera’s LED, the LED remains o until you turn it back on. If
you remove and replace your Arlo Go’s battery while the camera is not plugged in,
The LED lights as usual while the camera is powering up, and then it turns o again
as soon as the camera is done powering up.
¾ To turn o the LED and audio alerts:
1. Tap the Arlo icon
on your mobile device.
You can also enter arlo.netgear.com in the address bar of a browser.