NETGEAR Arlo Go

9
Set Up Your System
Insert the SIM Card Into Your Arlo Go Camera
The Arlo Go camera comes with an AT&T LTE SIM card installed. If a SIM card is not
installed, insert a card into the SIM card slot.
¾ To insert a SIM card:
1. Unlock the battery compartment by
pressing and holding the latch.
2. Gently pull the battery door back to open
the compartment.
3. Align the gold SIM contacts.
4. Insert the SIM card into the SIM card slot.
Note: If you plan to store video recordings on an
optional SD card (sold separately), insert the SD
card now.
Insert the Battery Into Your Arlo Go Camera
If power is available, you can plug your camera in and use it in powered mode. We
recommend that you insert the battery into your Arlo Go camera even if you plan
to power the camera using the power adapter.
¾ To insert the battery:
1. Align the battery contacts.
2. Insert the battery.
3. Close the battery door.
The Arlo Go camera plays a chime when it boots.
Note: The Arlo Go battery is partially charged when it leaves the factory.
SIM card slot
SD card slot