NETGEAR Arlo Go

25
Use an SD Card With Arlo Go
3. Insert the SD card into the SD card slot on the camera.
4. Press the edge of the SD card until it is completely seated in the slot.
5. Close the battery door.
6. Reboot the Arlo Go camera.
You must reboot the Arlo camera after installing an SD card.
View the SD Card Status
The Arlo app notifies you if the SD card is getting full or if the SD card is not the
correct format. You can also use the Arlo app to view the SD card status.
¾ To view the status of the SD card for a camera:
1. Tap the Arlo icon
on your mobile device.
If you are using a computer, enter arlo.netgear.com in the address bar of a
browser.
The Devices page displays.
2. Tap or click Settings > My Devices.
A list of cameras displays.
3. Tap or click the camera.
The camera settings display.
4. In the Storage section, tap or click SD Card.
The SD Card Status shows whether the SD card is ready, needs to be formatted,
or is full.
SD card slot