Advanced Settings
45
NETGEAR DOCSIS 3.0 N450 Wi-Fi Data Gateway
Enable Network Address Translation
Network Address Translation (NAT) provides one-to-many translation of IP addresses between
devices. This means that your network presents only one IP address to the Internet, and outside
users cannot directly address any of your local computers. Enable NAT to allow multiple
computers on your network to access the Internet using a single public IP address. NAT is
enabled by default.
To disable NAT:
1. In the main menu, under Advanced, select NAT.
2. Deselect the Turn NAT On box.
3. Click Apply.
Remove USB Devices
To remove a USB device:
1. In the main menu, under USB Storage, select Basic Settings.
2. Click Safely Remove USB Device.
To Next Page
Loading...
